How Do You Insert a Silhouette Infusion Set?

Inserting an infusion set can be a daunting task for someone who is new to using insulin pumps. An infusion set consists of a small tube that is inserted beneath the skin and connected to an insulin pump.

It is used to deliver insulin into the body, helping to maintain blood glucose control. However, there are several steps involved in inserting a Silhouette infusion set correctly, and it is important to make sure that each step is done properly in order to ensure that the set is inserted correctly and safely.

The first step in inserting a Silhouette infusion set is to make sure that your hands are clean and that you are working in a clean area. Then, check the expiration date on the packaging of the infusion set. If it has passed its expiration date, discard it and use a new one.

Next, attach the tubing to the reservoir of insulin. Make sure that it is securely attached so that there will not be any leaks or disconnections during insertion. Once attached, take out the needle guard from the needle assembly by grasping both ends of it and pulling away from each other.

After this, insert the needle into your skin at an angle of about 45 degrees. Push down firmly until you feel resistance; this indicates that you have reached your subcutaneous tissue. The next step is to press down on the back end of the needle with one hand while slowly twisting the plunger with your other hand until all of the insulin has been injected.

Once this has been done, remove your hands from both ends of the needle assembly and then carefully pull out just enough tubing so that it does not become kinked or twisted when you attempt to attach it to your pump. Finally, attach one end of tubing securely onto your pump reservoir and then connect it securely onto your skin.

Conclusion:
Inserting a Silhouette infusion set correctly requires several steps and must be done carefully in order to ensure proper placement and safety. It is important to make sure your hands are clean before beginning and check for any potential leaks or disconnections before inserting. Once inserted correctly, attaching one end of tubing securely onto your pump reservoir will complete the process.