How Do I Transfer My Cricut Vinyl Without Transfer Tape?

Transferring vinyl is an important part of the Cricut crafting process. It can be a bit tricky, but with some practice and the right supplies, it can be done with ease.

The most common method of transferring vinyl is to use transfer tape, but this isn’t always necessary. There are several other methods that you can use to transfer your vinyl without using transfer tape.

1. Using Rubbing Alcohol

Using rubbing alcohol is one of the easiest and quickest ways to transfer vinyl without transfer tape. It’s also one of the most cost-effective methods.

All you need to do is spray a generous amount of rubbing alcohol onto a clean cloth and rub it over the surface of your vinyl design. This will help loosen up the adhesive and make it easier to remove from its backing paper.

2. Using Heat

Applying heat directly to your vinyl design can also help you remove it from its backing paper without using transfer tape. You can use a heat gun, hairdryer, or even an iron on low heat setting if you prefer this method. Simply hold the tool directly over your design for several seconds until it becomes slightly tacky, then carefully peel it off the backing paper.

3. Using Soap and Water

If you don’t have any rubbing alcohol or heat tools at hand, soap and water will do just fine as well. Fill a bowl with warm soapy water and submerge your vinyl design into it for about 10 minutes. This will help soften up the adhesive so you can easily peel off the backing paper without any assistance from transfer tape.


No matter which method you choose, transferring Cricut Vinyl without transfer tape is possible! Just make sure to take extra care when handling your design so that it doesn’t get damaged in the process. With some practice and patience, you should be able to master this skill in no time!