Setting up an Alta Silhouette can be a daunting task if you’re not familiar with the process. However, once you know what to do, it’s simple and straightforward. The following steps will guide you through the setup of your Alta Silhouette:
Step 1:
Attach the base of your Silhouette to the stabilizing stand. You should be able to see the two mounting holes on either side of the base.
Line up these mounting holes with the corresponding screws on either side of the stand. Using a Phillips screwdriver, tighten both screws until the base is firmly attached.
Step 2:
Check that all components have been included in your package. These should include an accessory box containing a power cord, USB cable and cutting mat. In addition, make sure that there is enough room around your Silhouette for easy access and movement.
Step 3:
Connect your Silhouette to a power source. Plug one end of the power cord into an outlet and then connect it to your Silhouette at the back of its base. Connecting to a surge protector is recommended for added protection.
Step 4:
Install cutting software on your computer or laptop if necessary. You can find compatible software on Silhouette’s website or through other third-party vendors.
Step 5:
Connect your computer or laptop to your Silhouette via USB cable. This will allow you to send designs from your computer directly to your Silhouette for cutting.
Step 6:
Place compatible media (vinyl, fabric, paper etc.) onto the cutting mat, making sure that it is centered and aligned properly before loading it into the machine.
Step 7:
Once all components are set up and connected, open up your cutting software and begin creating designs! You’ll be able to cut out any shape or design imaginable!
Conclusion
< p > Setting up an Alta Silhouette is easy once you understand each step involved in its setup process. By following these seven steps outlined above, you will have successfully installed and set up an Alta Silhouette in no time!