If you have recently acquired a Hermes 3000 typewriter, you may be wondering how to open it up for cleaning or repair. The Hermes 3000 is a classic typewriter that has been around for decades, and its design has remained virtually unchanged.
However, opening it up can be a bit tricky if you don’t know what you’re doing. In this tutorial, we’ll take a look at the steps involved in opening up your Hermes 3000 typewriter.
Gather Your Tools
Before we dive into the steps involved in opening up your Hermes 3000 typewriter, make sure to gather all the necessary tools. You will need a screwdriver (preferably a small Phillips head), tweezers, and a soft-bristled brush.
Step-by-Step Guide
1. Flip the Typewriter Over
To start, flip your Hermes 3000 typewriter over onto its backside. Make sure to place it on a soft surface such as a towel or blanket to prevent scratches or damage.
2. Remove the Carriage Cover Screws
Next, locate the carriage cover screws on the bottom of the typewriter. There should be two screws on either side of the carriage cover. Use your screwdriver to remove them.
3. Remove the Carriage Cover
Once you have removed the screws, gently lift off the carriage cover by pulling it towards you from both sides. Be careful not to damage any of the components inside while doing so.
4. Remove Any Obstructions
With the carriage cover removed, check for any obstructions or debris that may be blocking access to other parts of your Hermes 3000 typewriter. Use tweezers or your soft-bristled brush to remove any dirt or debris that you may come across.
5. Open Up the Typewriter
Once you have cleared any obstructions, you can now open up your Hermes 3000 typewriter. Gently push the platen (the rubber roller that holds the paper) towards the front of the typewriter to release it from its bearings. Then, lift up on the platen and set it aside.
6. Access Components
With the platen removed, you should now have access to other components inside your Hermes 3000 typewriter. You can now clean or repair any parts that need attention.
Conclusion
Opening up your Hermes 3000 typewriter may seem intimidating at first, but with the right tools and a little bit of patience, it’s a straightforward process. Remember to be careful when handling any of the components inside and take your time to ensure that everything is done correctly. By following these steps, you’ll be able to access all parts of your Hermes 3000 typewriter and keep it in good working condition for years to come.