Lighting a Ruud Silhouette furnace is an easy process, but should only be done by qualified professionals. Before attempting to light the furnace, it is important to make sure that all safety measures have been taken.
This includes ensuring that the gas supply and power are both turned off before beginning any work. Once you have all of the necessary safety steps completed, lighting the Ruud Silhouette furnace is a straightforward process.
The first step is to locate the pilot control knob on the front of the furnace. This knob will need to be set to “Pilot” mode.
Then, locate and press down on the red reset button on the furnace. You will need to hold this button down while turning on your gas supply and igniting your pilot light.
Once you have ignited your pilot light, you will need to continue holding down the reset button for approximately one minute. During this time, you should also adjust your thermostat setting to ensure proper operation of your furnace. After releasing the reset button, you should be able to see a small flame burning near the base of your furnace.
It is important to note that if you do not see this flame burning after releasing the reset button, then you may need to repeat steps 2-4 until it ignites properly.
Once your pilot light has been successfully lit and you can clearly see a small flame burning near the base of your furnace, then you can turn your gas supply back off and turn up your thermostat setting as desired. At this point, your Ruud Silhouette furnace should be working properly and providing heat for your home.
Conclusion:
Lighting a Ruud Silhouette furnace is an easy process that can be done with just a few simple steps.
Before attempting any work on a Ruud Silhouette furnace, it is important that all safety measures are taken including shutting off both gas and power supplies. Once these safety measures are taken care of, lighting the Ruud Silhouette furnace involves setting its pilot control knob to “Pilot” mode and pressing down on its red reset button while igniting its pilot light from outside of its casing. After succeeding at these steps and ensuring that there is a small flame burning near its base after releasing its reset button, then it should be operational for providing heat for your home.