Removing the blade from a Silhouette Cameo 4 is a relatively easy process, but it should be done with care. It is important to remember that the blade is very sharp and can cause injury if not handled properly. To begin, locate the blade-loading compartment on the left side of the machine.
Open this compartment by pressing and holding down the grey ‘Blade release button’ for approximately two seconds. This will cause the blade holder to move forward and expose the black blade holder assembly.
Once exposed, use your fingers to turn the ‘Blade Adjustment Dial’ until it clicks three times – this will reduce the pressure of the blade against its holder. Next, grab onto both sides of the black plastic assembly with your fingers and carefully pull upwards until it pops out of its compartment. The Silhouette Cameo 4 blade should now be free from its holder.
After removing the blade, you may now replace it with a new one if desired. To do this, insert your new Silhouette Cameo 4 blade into its holder and press down firmly until it clicks into place – you should feel a slight resistance as it slides into position. Once secure, rotate the ‘Blade Adjustment Dial’ clockwise until it clicks three times – this will increase pressure on your new blade.
Conclusion:
Removing a Silhouette Cameo 4 Blade is an easy process that requires minimal effort and just a few simple steps. To start, open up the Blade Loading Compartment by pressing and holding down the grey button for two seconds before rotating the Adjustment Dial three clicks to reduce pressure on your current blade. Finally, carefully pull up on both sides of the black plastic assembly until it pops out before replacing with a new one if desired.